Carving Bars
Chain saw carving bars are popular with wood and ice carvers as well as log builders for performing “”plunge”” cuts and detail work with minimal kickback.
We’re discontinuing carving bars, chains, sprockets…just too busy to keep it organized. Check back in as the remaining bars etc. will continue to be discounted until they’re gone.
When you place the bars you’re considering into the shopping cart…you’ll then see a ‘Promo Code’ box on the shopping cart page. Enter ‘Carving Bar’ into the box to see what the current discount is.
To find out whether your saw has a 1/4 pitch Spur Sprocket available click HERE.
Look HERE for information on determining pitch and gauge of saw chain.
Note: When ordering chain or bars, please include make and model of saw. (not necessary if you’re an experienced chain saw carver and know what you’re ordering is correct). If possible, let us know the pitch and gauge of the chain.
Note: When you receive a carving bar from us you’ll find that we have (when we remember), applied some “”slick 50″”, or similar lubricant at the bar tip to provide adequate lubrication until the saw “”oiler”” has dispensed sufficient oil into the bar groove to lubricate the entire bar length. This is particularly important on manual oilers such as the Makita 5012b.
Note: Carving Bars are designed to accommodate several different bar mount styles. Occasionally, you may need to file out the bar stud groove to allow the bar to slide into place and tighten up properly. This filing can be easily done with a good flat file or round file as the circumstances dictate.
Showing all 4 results