Need help navigating this site? Try HERE!

Sashco's Transformation Data and Application Information

Coverage

Varies with wood porosity. First coat will cover 150-300 sq. ft. per gallon. The second coat, 250-450 sq. ft. per gallon. Apply a 3rd coat when using the color "Natural". (As with all stains, coverage will vary depending upon roughness of the wood.)

Recommended film thickness: 3 mils (use a gauge if in doubt)

Application Range

Surface temperature should be 45°F minimum and rising, 90°F maximum and falling. The coating should be applied and allowed to dry within this temperature range. Application and curing below the minimum risks slow drying which could lead to rain or snow damage. Application above the recommended maximum risks drying too fast, with poor penetration into the wood. Best performance: Between 50°F and 90°F

(Note: When cold and/or humid nights are expected, apply coatings no later than mid-afternoon to allow adequate drying time before exposure to severe conditions.)

Maintenance

Maintenance is very important for prolonged high performance, so plan to inspect your home each spring and fall for any problems with stain, caulking, chinking, rot, etc. Routine reapplication of one or more coats of Transformation, or Cascade water-borne clear coat may be applied for routine maintenance.

Within the first 12-18 months after Transformation was first applied, it is important to inspect the building to see if any areas did not receive an initially adequate amount of stain, which can sometimes happen in localized areas when the stain is first applied. If you locate such areas, simply clean the surfaces with damp rags or bristle brushes to remove dirt, pollen, etc., and then apply more Transformation.

Clean-Up

Brushes and equipment should be cleaned with mineral spirits.

Follow local, state and federal guidelines for disposing of empty cans or any unused product. Keep containers tightly closed when not in use. Hands may be cleaned with such cleaners as Go-Jo or orange-based hand cleaners, then washed with soap and water.

Packaging

One gallon, five gallon pails and 1/4 pint samples available.

Tecnical Data

  • VOCs: Less than 550 grams/liter (Not to be considered specifications.)
  • Shelf Life: 3 years from date of manufacture (minimum, unopened pail stored at room temperature)
  • Compatibility: Transformation Stain® is recommended for use with all other Sashco products. It also works well with most other caulking/chinking, and clear exterior coatings. Please contact Sashco for details on specific compatibility questions.
  • Dry Time: Transformation dries to the touch in 30 minutes or less in ideal weather. However, we recommend waiting at least 12 hours before applying a second coat. Slight tackiness may persist for 3-5 days.
  • Viscosity: Brookfield LVF, 30-40 cps; spindle #2, 60 rpm
  • Density: 7.0 - 7.5 lb./gal.
  • Solids: 38-40%, depending on color
  • Odor: Mild, mineral spirits

Color Testing Procedure

To be assured you achieve the color you want on your home, follow these important steps:

  • Read the entire Transformation Stain® Data:Tec before testing for color.
  • Test Transformation on an inconspicuous section of your home that has been surface prepped with the method that you’ve selected after considering the longevity that you desire and the intensity of color.
  • Use the same application method you plan to use on your home.
  • Apply the first coat as heavily as possible, and let it dry 4-24 hours.
  • Apply the second coat heavily, let it dry, and then evaluate the color.
  • Don’t allow the contractor to stain until you have thoroughly discussed and demonstrated the look you want. Show him the test section that you’ve approved for color.
  • Don’t apply Transformation to the entire home before you verify that you’re achieving the look you want.

Due to the extreme transparency of Transformation Stain, the color of the stain you select will be influenced by the color of the underlying wood. Therefore, it is very important to test the stain on your home to be certain that you get the color you want.

Storage

Do not store in direct sunlight or hot conditions. The shelf life is a minimum of 3 years from the date of manufacture when stored at room temperature in unopened containers.

CAUTION!

Combustible. Contains Petroleum Distillates. Keep away from sparks, heat, flames and sources of ignition. Do not smoke while using product. May be harmful if inhaled or swallowed. May be irritating to skin and eyes. For exterior use only – where good ventilation can usually be achieved. Not for interior use. Avoid breathing vapors. Wear a vapor respirator when spraying that conforms to the requirements of NIOSH/MSHA TC 23C, or equivalent.

DANGER!

If improperly stored, such items as rags, drop cloths, steel wool or other objects laden with Transformation Stain or solvents may spontaneously catch on fire. It is best to place such items in a water-filled metal container, and in no case should such items be stored in or near buildings, vehicles or other valuable structures which could catch fire if spontaneous combustion should occur.

First Aid

IF SWALLOWED: DO NOT INDUCE VOMITING.

CALL DOCTOR IMMEDIATELY.

  • EYES: Flush eyes immediately with water for 15 minutes. Call doctor.
  • IF INHALED: Move to fresh air. If symptoms persist, call doctor.
  • SKIN: Wash skin thoroughly with soap and water. Remove contaminated clothing – and wash clothing right away. Call doctor if skin irritation persists. Refer to the MSDS for this product as needed.

NOTICE

Reports have indicated that repeated and prolonged occupational overexposure to solvents can lead to permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the vapors from this product may be harmful or fatal. WARNING: This product contains a chemical reported by the state of California to cause cancer.

WARNING!

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424- LEAD or log on to www.epa.gov/lead.