Barker

Shown above is complete unit

Select from the following *

Wood Clamp and Drill Carriage Combo $565.00
Wood Clamp only $350.00
Drill holder with carriage $225.00

Choose drill chuck size-
needed when ordering
drill holder or combo kit

1/2" chuck
see notes below
3/4" chuck
see notes below

st0102-3-Barker-c&c

Barker Clamp and Carriage

Barker clamp and carriage is a two part unit.

Note: You can order the parts individually, however they normally are ordered together.

(sometimes called a 'slide base' or 'drill holder'), is actually two components.(shown above on right holding drill and on sliding rails)

The drill then glides along the carriage slide toward the log material that is secured in the clamping device.

Is designed to easily center material to line up with the drill chuck. (shown above on left holding wood stock)

Clamps on each side of the round stock move toward the centering point simultaneously which keeps your log stock centered on the tenon cutter head.

NOTE: Drill holder can be ordered to fit either of the following:

3/4" drive Milwaukee Super Hole Shooter Model #1854-1...for this specify the 3/4" chuck size
1/2" Milwaukee Drill Model #1663-20
(The Milwaukee #1660-1 is a single speed version of the #1663.20...It can be made to work. You'll need to bend the metal clamp on the carriage so the "trigger" on the drill is accessable). For these order the 1/2" chuck size.

For any sort of production work we recommend the 3/4" drive drill for its durability.